Overview
Raceel Design offers a wide range of real time training classes that help you apply to enhance your skills. Our experienced instructors apply hands-on techniques that improve learning retention and on-the-job productivity.
Signal Integrity :
This course is designed for to freshers & working professionals.
Course Outline:
- Basics of Electromagnetic analysis (as applicable to signal integrity)
- Transmission lines & their effects
- Reflections & impedance mismatch analysis
- impedance concept (Z0 : single-ended & differential)
- Crosstalk (near-end/far-end)
- Switching noise (SSN)
- s-parameter & TDR
- stackup design, via design & quality routing concepts.
- Signal integrity topology analysis & termination effect
- Power Integrity basics
- Target impedance design
- decoupling cap selection and analysis
- Hands-on simulation experience on DDR3 & PCIe
- High speed serial/parallel interface analysis and design guidelines (DDR3, DDR4, multi-gigabit Serdes, PCIe gen3 & gen4, XAUI, HDMI, SATA, USB, chip-to-chip IO, FPGA IO)
- Signal integrity & power integrity co-design SSN modeling
- pre-layout & post-layout SI/PI analysis.
- IBIS/IBIS-AMI based system level SI evaluation.
- Routing studies, termination schemes, stackup design & analysis.
- Trace (microstrip, stripline, CPW) & Via design for controlled impedance using EM solver.
- Full-wave EM modeling of all kinds of interconnects (via, connector, end-to-end channel)
- Crosstalk and s-parameter modeling of traces and interconnects on package and board.
Power Integrity Training:
We do offer specialized Power integrity training to freshers & working professionals.
Course Outline:
- Analyze and verify power supply quality at chip, package & board level.
- Target impedance estimation and optimization.
- Decoupling cap estimation and optimization
- Power-ground loop inductance & stackup optimization.
- S-parameter & parasitic extraction (R,L,C)
- IR drop analysis and give recommendation about placement of components.
- time-domain power integrity noise estimation.
"For training requirement, contact us at This email address is being protected from spambots. You need JavaScript enabled to view it."
